PDA

View Full Version : Camology 101: How to read cam specs


ResearchTeam
05-06-2006, 02:44 PM
How To Read A Cam Card
Why the heck would you want to read a cam card?! Better yet, how do you read a cam card?! When you purchase a cam, a cam card is provided to help the installer understand more about the cam set-up. This usually gets thrown out with the box the cam came in, because most of the time the cam you purchased is a tried-and-true product. Since knowledge is power, we compiled the following cam card guidelines to help you better understand what it is you just purchased. This is vital information, because there is a lot more to a camshaft than lift and duration.

http://photo.hondatech.com.au/camology%20101/0104tur_cams23_zoom.jpg


A: Intake & Exhaust Duration: This is measured in degrees of how long the valves are open. This number is rated at the camshaft and end result will be the same at the valve.
B: Intake & Exhaust Lift: This is measured in inches and in most cases this number refers to the valve lift and not cam lift. Valve lift is the measurement at the valve side of the rocker arm. This number is a calculation of cam lift with rocker ratio figured into the equation. (See D rocker ratio)
C: Intake & Exhaust Clearances: This is the recommended valve lash for these particular cams. The measurement is given in inches and the card explains that measurements should be done with the engine cold.
D: Rocker Ratio: The rocker ratio is the proportional relationship between measured lift at the cam and measured lift at the valve based on a rocker arms fulcrum point.
E: Duration @ .050: This is the U.S. standard of measurement. U.S.-spec cams are measured at .050 thousands of an inch.
F: Lobe Lift: This is the actual lift of the cam without the rocker ratio calculated into the equation. Cam lift is figured by measuring the cam from the tip of its ramp to the bottom of the base circle. Then measuring the base circle and subtracting the base circle measurement from the tip-to-base measurement.
G: Lobe Center: This is also referred to as lobe separation angle. Lobe center is measured in degree comparisons between the intake lobes and the exhaust lobes from the center of the camshaft. Since most imports are DOHC this number can be tailored with the use of cam sprockets. DOHC engines have two centers because of the use of two cams. Since changing the degrees on the cams can widen or shorten the lobe separation angle this number is often ignored. On single-cam engines this number is fixed since the intake and exhaust lobes are on the same shaft.


------------------------------------------------------------------------------------------------------------------------------
We hoped you enjoyed reading this article. If you would like to know more about a subject or found an interesting article, email researchteam@hondatech.com.au about it so that we can build our library and educate all our fellow members.

reference: turbo magazine